Ultrameter: Measuring Conductivity, TDS and Resistivity: MyronLMeters.com

Posted by 1 Mar, 2014

Please note:  These procedures apply to Ultrameters, Pool Pros, Tech Pros, and D-4 and D-6 dialysate meters.

Measuring Conductivity & TDS

1. Rinse cell cup 3 times with sample to be measured. (This conditions

the temperature compensation network and prepares the cell.)

2. Refill cell cup with sample.

3. Press COND or TDS.

4. Take reading. A display of [- - - -] indicates an over range condition.

Measuring Resistivity

Resistivity is for low conductivity solutions. In a cell cup the value may drift from trace contaminants or absorption from atmospheric gasses, so measuring a flowing sample is recommended.

1. Ensure pH protective cap is secure to avoid contamination.

2. Hold instrument at 30° angle (cup sloping downward).

3. Let sample flow continuously into conductivity cell with no aeration.

4. Press RES key; use best reading.

NOTE: If reading is lower than 10 kilohms display will be dashes: [ - - - - ]. Use Conductivity.

If you have further questions, please watch our Ultrameter 6P product overview video here: http://blog.myronlmeters.com/ultrameter-ii-product-review/

 IV. AFTER USING THE ULTRAMETER II

Maintenance of the Conductivity Cell

Rinse out the cell cup with clean water. Do not scrub the cell. For oily films, squirt in a foaming non-abrasive cleaner and rinse. Even if a very active chemical discolors the electrodes, this does not affect the accuracy; leave it alone.

Myron L Meters is the premier internet retailer of Myron L meters, solutions, parts and accessories. Save 10% on the Ultrameter II 6PFCe when you order online at MyronLMeters.com.

Categories : Application Advice, Technical Tips
loading comments...